The Forum

Here is a photo of the board set up for a scenario set during the First Battle of the Marne. You can see the Kallistra Hexon terrain peeking out from under the terrain cloth. More views to come once the scenario has been play tested. The Marne river is at the bottom of the photo. The view is looking roughly from South to North. The area was the scene of German rearguard action to delay the advance of the BEF.
Robert

Really well done.
My compliments.

Andrea

Hi Robert

Nice neat setup. As we discussed before kallistra can be used to good effect under a cloth for topography. In the setup shown in your photograph has the kallistra been used to raise some parts of the terrain up or are the kallistra hexes flat? If there is a variation would you kindly either show a graphic of the hexes raised or a photograph of the kallistra please.

Best regards

Graham

Hi Graham,

I didn't take a photo of the Hexon terrain during set up. Once the play testing is done then I will post a photo for you. Meanwhile here are the graphics of the hexes by level. And here is a view taken near ground level, looking towards Nanteuil. You can see the TimeCast latex cobbled road winding up from Nanteuil towards the plateau where the farms are located. Robert

And here is another photo of Nanteuil again but taken at table level. The buildings are Paper Terrain 3mm, which I find is a better scale visually for 6mm figures. Just a personal taste thing: Robert

very nice like the woods